If your RV or camper water heater isn‘t firing up, it’s probably the igniter electrode that‘s gone bad.

This pack comes with two replacement igniters that are a direct fit for a whole bunch of Atwood water heaters—think models like Gch6-4e, Gch6-6e, Gch6-7e, Gch6a-10e, Gc6aa-10e, Gc6a-7e, Gh6-3e, Gh6-4e, and similar.

Just a heads-up, this isn’t an OEM Atwood part, but it‘s built to match perfectly and get the job done.

Each electrode is made from quality metal and ceramic, so they hold up to heat and don’t break easily.

The metal plate part is about 5.4 x 4 cm (roughly 2.13 x 1.57 inches), and the total length from ceramic to tip is about 8.5 cm (3.35 inches).

When you install it, make sure the gap between the spark probe and the ground probe is about 1/8 inch—that‘s the sweet spot for a reliable spark.

These things are all about getting your heater back to peak efficiency.

Faster heating, more reliable ignition, and no more cold showers on camping trips.

Installation is straightforward—just pull the old one out, pop this one in, and you’re done.

The set comes with two, so you‘ve got a spare on hand for next time.

Colors are black, silver, and white mix, but that’s just the materials showing through—nothing to worry about.