Installing concealed hinges can be a pain – drill a hole a little off and your cabinet door won't close right.

The Milescraft EuroHingeJig takes the guesswork out of it completely.

This jig gives you perfect, repeatable 35mm hinge cup holes every single time, whether you're working on framed or frameless cabinets.

The jig has two edge alignment knobs that position the cup hole from the edge of the door, and an edge locator pin sets the vertical position at either 3 or 4 inches – the two most common distances.

The metal bushing drill guide locks into place and gives you a straight, accurate hole that doesn't wear down over time like plastic guides do.

And yes, a 35mm Forstner bit is included – ready to go out of the box.

There are also guide bushings built into the body for pre-drilling pilot holes in four common locations – so your hinges line up perfectly and your door closes true.

The included 1/16-inch drill bit handles those pilot holes.

Built-in depth gauges on both sides let you set your hinge hole depth to one of two depths, so you're not guessing or marking with tape.

The hinge marking guide detaches from the bottom and helps you transfer center lines and hinge locations to the cabinet wall or frame – super handy for layout.

Includes an Allen key and a cabinet locator measuring tool too.