Programming A Device

Programming A Device

The MPLAB® IPE Program feature allows you to connect to the hardware programmer and perform a program operation. Before programming a device; the IPE, the programmer, and target device must be connected. For further information on how to connect the IPE to your programmer of choice, please refer to the Setting Up a Programmer page.

1

Make sure the IPE is successfully connected to the programmer/debugger. The IPE output window will show messages indicating whether the IPE is successfully connected or not. The figure below shows an example of the IPE connected to an MPLAB® ICD 3, and the target device is detected..

IPE_connected.png

2

To program the device, click the Program button, as shown below.

IPE_program_button.png

3

If the device is programmed successfully, the output window will show the message: Programming/Verify complete, as shown below:

IPE_programming_device.png
​

Note:
Short-cut key combination Alt-F5 can be used to Program a device in the IPE. For further information on other command short-cut keys, please refer to the Launching the IPE Application page.

  Return to Top